Emergency-capable service
Water damage restoration in the Phoenix metro
Water damage restoration means removing standing water, drying the building to a measured dry standard, and removing materials that can't be saved. Start within 24 to 48 hours; after that, swollen wood, delaminated drywall and mold become far more likely, even in Arizona's dry air.
- Fast call-back for active leaks
- Phoenix metro
- Free to call
How the job runs
- 1Stop the source and assessThe technician confirms the water is off, checks electrical safety, and uses moisture meters and a thermal camera to map how far water travelled.
- 2ExtractTruck-mounted or portable extractors remove standing water from carpet, pad and hard floors. Wet pad is usually pulled and discarded.
- 3Dry and monitorAir movers and dehumidifiers run for several days. Readings are taken daily and logged until materials reach a dry standard set against unaffected areas.
Most Valley homes are built slab-on-grade with drywall walls and baseboards that wick water upward. Water from a failed supply line or water heater spreads under flooring and into the bottom of walls long before it looks serious. The restoration company's job is to find where the water went, not only where it's visible.
A proper job has three parts: stop and extract, dry with equipment while taking daily moisture readings, then rebuild what was removed. Ask for the moisture log and photos at each step; your insurance adjuster will want both.
Water damage restoration at a glance
- Best time to start
- Within 24–48 hours of the leak
- Typical drying time
- 3–5 days for clean water, longer for slab and cabinets
- Key paperwork
- Moisture log, photos, equipment list
- Who does the work
- An independent, insured restoration company
Warning signs
Signs you need water damage restoration
- Carpet or pad that feels damp several feet from the source
- Baseboards that are swelling, separating or discolored
- Laminate or vinyl plank that is cupping or lifting at the seams
- A musty smell a day or two after a leak was 'cleaned up'
- Stains or bubbling paint on the lower 12 inches of walls
Process
What the restoration company does
- 1
Stop the source and assess
The technician confirms the water is off, checks electrical safety, and uses moisture meters and a thermal camera to map how far water travelled.
- 2
Extract
Truck-mounted or portable extractors remove standing water from carpet, pad and hard floors. Wet pad is usually pulled and discarded.
- 3
Dry and monitor
Air movers and dehumidifiers run for several days. Readings are taken daily and logged until materials reach a dry standard set against unaffected areas.
- 4
Remove and rebuild
Drywall, insulation or flooring that can't be dried is cut out. Repairs follow once everything reads dry.
Cost
What affects the cost
Every loss is different, so honest pricing starts with an on-site assessment. These are the factors that move the number.
- Category of water: clean supply water, gray water from appliances, or contaminated black water
- How many rooms and how many square feet of flooring and wall are wet
- How long materials were wet before drying started
- Flooring type: carpet and pad dry differently from laminate, hardwood or tile over slab
- Whether drywall, cabinets or insulation need removal and rebuild
Safe to do now
- Shut off the main water valve and, if it's safe, the breaker for wet areas
- Move furniture, rugs and electronics off wet floors
- Take photos and video of every wet area before anything is removed
- Wipe up surface water and open interior doors
Stop and call if
- Water is near outlets, a panel or appliances that are still powered
- Ceilings are sagging or sounds of dripping come from inside a ceiling
- The water came from a toilet, sewer line or outside flooding
- Wet areas are larger than one small room
FAQ
Water damage restoration: common questions
How fast should water damage be dried out?
Drying should start within 24 to 48 hours. Mold can begin growing on wet drywall and wood in that window, and flooring and cabinets swell the longer they sit wet.
How long does the drying take?
Most clean-water jobs dry in three to five days of continuous equipment use. Tile over slab, cabinets and wall cavities can take longer, which is why daily moisture readings matter more than a fixed schedule.
Will homeowners insurance pay for water damage restoration?
Most policies cover sudden and accidental water damage, like a burst supply line. They usually exclude long-term leaks and outside flooding. Call your insurer early and keep every photo and the restoration company's moisture log.
Common in these Valley cities
Water where it shouldn't be?
Shut off the water, then call. One call connects you with an independent restoration company near you.
Fast call-back for active leaks